Air Intake Control Actuator Inspection; Temperature Control Actuator Removal And Installation; Temperature Control Actuator Inspection; Hvac Control Module Removal And Installation - Suzuki Grand Vitara 2011 Manual

Hide thumbs Also See for Grand Vitara 2011:
Table of Contents

Advertisement

7B-81 Air Conditioning System:

Air Intake Control Actuator Inspection

Refer to "Air Intake Control Actuator Inspection in
Section 7A".
Temperature Control Actuator Removal and
Installation
Refer to "Temperature Control Actuator Removal and
Installation in Section 7A".

Temperature Control Actuator Inspection

Refer to "Temperature Control Actuator Inspection in
Section 7A".

HVAC Control Module Removal and Installation

Refer to "HVAC Control Module Removal and Installation
in Section 7A".
A/C Compressor Drive Belt Inspection and
Adjustment
For M16 engine model referring to "P/S Pump and A/C
Compressor (If Equipped) Drive Belt Inspection and
Adjustment (M16A Engine Model) in Section 6C".
For J20 engine model referring to "Water Pump and
Generator Drive Belt On-Vehicle Inspection (For J20
Engine): For Petrol Engine Model in Section 1J".
For F9Q engine model referring to "Accessory Drive Belt
Inspection: For Diesel Engine Model in Section 1J".
A/C Compressor Drive Belt Removal and
Installation
For M16 engine model referring to "P/S Pump and A/C
Compressor (If Equipped) Drive Belt Removal and
Installation (M16A Engine Model) in Section 6C".
For J20 engine model referring to "Water Pump and
Generator Drive Belt Removal and Installation (For J20
Engine): For Petrol Engine Model in Section 1J".
For F9Q engine model referring to "Accessory Drive Belt
and Idler Pulley Removal and Installation: For Diesel
Engine Model in Section 1J".

A/C Compressor Relay Inspection

S6JB0A7206026
For M16 Engine Model
1) Disconnect negative (–) cable at battery.
2) Remove compressor relay (1) from vehicle.
3) Check that there is no continuity between terminal
"c" and "d". If there is continuity, replace relay.
S6JB0A7206027
4) Connect battery positive (+) terminal to terminal "b"
of relay.
Connect battery negative (–) terminal to terminal "a"
of relay.
Check continuity between terminal "c" and "d".
S6JB0A7206028
If there is no continuity when relay is connected to
the battery, replace relay.
S6JB0A7206029
S6JB0A7206030
S6JB0A7206031
1
c
a
b
d
S6JB0A7206032
I5JB0A720056-01

Advertisement

Table of Contents
loading

Table of Contents