3C-57 Transfer: Motor-Shift Type (Transfer with Shift Actuator)
Transfer Switch Inspection
Check continuity between following terminals when
transfer switch (1) operated at each position.
Switch position
Terminal
(2)
N (3)
4H (4)
4H-lock (5)
4L-lock (6)
[A]
6 5 4 3 2 1
4
3
2
[A]: Transfer switch connector (harness side view)
S6JB0A3316005
1 – 2
1 – 2 – 3
1 – 3
1 – 3 – 4
1 – 4
5
6
1
I5JB0A331004-04
4WD Control Module Removal and Installation
Removal
1) Disconnect negative (–) cable from battery.
2) If the vehicle is equipped with air bag system,
disable air bag system. Refer to "Disabling Air Bag
System in Section 8B".
3) Disconnect connectors from 4WD control module
(1).
4) Remove 4WD control module with TCM by removing
its nuts, and then separate 4WD control module and
TCM.
Installation
Reverse removal procedure for installation noting the
following.
• Connect 4WD control module connectors securely.
• If the vehicle is equipped with air bag system, be sure
to enable air bag system after 4WD control module is
back in place.
Refer to "Enabling Air Bag System in Section 8B".
S6JB0A3316006
1
I5JB0A331005-01