Dtc B1017: Power Source Voltage Low - Suzuki Grand Vitara 2011 Manual

Step
2 1) With ignition switch OFF, reconnect SDM connector.
With ignition switch ON, is DTC B1016 indicated?
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to "DTC Clearance", if any.
• Repeat "Air Bag Diagnostic System Check" to confirm that the trouble has been corrected.

DTC B1017: Power Source Voltage Low

Wiring Diagram
Refer to "DTC B1016: Power Source Voltage High".
CAUTION
!
Be sure to observe instructions under CAUTION in "Air Bag Diagnostic System Check Flow".
DTC Will Set when
The power source voltage is below specified value for specified time.
Flow Test Description
Step 1: Check if voltage on battery is within normal range.
Step 2: Check if voltage applied to SDM is within normal range.
Step 3: Check if voltage applied to "L04" connector is within normal range.
Step 4: Check if DTC B1017 still exists.
DTC Troubleshooting
Step
1 1) Measure voltage on battery.
Is voltage 11 V or more?
Action
Action
Air Bag System:
Yes
Substitute a known-
good SDM and recheck.
Yes
Go to Step 2.
8B-26
No
Intermittent trouble.
Check for intermittent
trouble referring to
"Inspection of
Intermittent and Poor
Connections" If OK,
substitute a known-
good SDM and recheck.
S6JB0A8204013
No
Check charging system
and repair as necessary
referring to "Generator
Test (Undercharged
Battery Check): For
Petrol Engine Model in
Section 1J" or
"Generator Test
(Undercharged Battery
Check): For Diesel
Engine Model in Section
1J".