Suzuki Grand Vitara 2011 Manual page 713

7) Tighten transmission to engine bolts referring to
"Manual Transmission Assembly Dismounting and
Remounting: For Diesel Engine Model in Section
5B".
8) Connect ventilation pipe No.1 (1) and ventilation
hose No.3 (2) to upper oil pan with new O-ring.
Tightening torque
Ventilation pipe No.1 bolt (a): 10 N·m (1.0 kgf-m,
7.5 lb-ft)
1
(a)
9) Install suspension frame referring to "Front
Suspension Frame, Stabilizer Bar and/or Bushings
Removal and Installation in Section 2B".
10) Install fresh air vent union bolt (1) to lower oil pan
with new gasket, if removed.
Tightening torque
Fresh air vent union bolt (a): 30 N·m (3.0 kgf-m,
22.0 lb-ft)
1, (a)
Engine Lubrication System: For F9Q Engine 1E-26
11) Install lower oil pan (1) to upper oil pan with new
gasket, and tighten lower oil pan bolts evenly and
gradually in numerical order ("1" through "4") by
repeating tightening sequence two or three times
until specified torque is obtained.
Tightening torque
Lower oil pan bolt (a): Tighten 22 N⋅m (2.2 kgf-m,
16.0 lb-ft) by the specified procedure
(a), "1"
2
I5JB0B150024-01
12) Install lower oil pan stiffener No.1 (1) and No.2 (2),
and tighten lower oil pan stiffener No.1 and No.2
bolts according to numerical order ("1" though "4") as
shown in figure.
Apply thread lock "A" to lower oil pan stiffener bolt
marked "2".
"A": Thread lock cement 99000–32030 (Thread
Lock Cement Super 1303B)
Tightening torque
Lower oil pan stiffener bolt (a): Tighten 32 N⋅m
(3.2 kgf-m, 23.5 lb-ft) by the specified procedure
I5JB0B150025-01
(a), "3"
(a), "4"
(a), "3"
1
(a), "4"
(a), "2"
1
I5JB0B150026-01
(a), "1"
2
"A", (a), "2"
I5JB0B150027-01