Accessory Drive Belt And Idler Pulley Removal And Installation - Suzuki Grand Vitara 2011 Manual

1J-28 Charging System: For Diesel Engine Model
Accessory Drive Belt and Idler Pulley Removal
and Installation
Removal
WARNING
!
Disconnect negative (–) cable at battery
before removing and installing generator
belt.
1) Remove engine under cover.
2) Loosen tensioner by turning the tensioner (1)
clockwise.
3) While holding the tensioner and belt loose.
4) Loosen tensioner bolt No.1 (2) and remove breather
front No.1 hose clip (3).
5) Remove accessory drive belt (4).
CAUTION
!
Do not apply any oil or grease to the
accessory drive belt.
6) Loosen idler pulley bolt (7) and then remove idler
pulley (5) and adapter (6).
3
4
S6JB0A1A26006
2
5 1
6
5
7
I5JB0B1A0027-01
Installation
1) Install adapter (6) and then tighten adapter.
2) Install idler pulley (5) and then tighten idler pulley
bolt (7) to specified torque.
Tightening torque
Idler pulley bolt (b): 50 N·m (5.0 kgf-m, 36.5 lb-ft)
3) Install accessory drive belt (4).
4) Tighten tensioner bolt No.1 (2) and install breather
front No.1 hose clip (3).
Tightening torque
Accessory drive belt and belt tensioner bolt
No.1 (a): 50 N·m (5.0 kgf-m, 36.5 lb-ft)
5) Loosen tensioner by turning the tensioner (1)
clockwise.
6) While holding the tensioner, install accessory drive
belt (4).
NOTE
Make sure that the belt fits each pulley's
groove properly.
3
4
7) Install engine under cover.
2,(a)
1
5
6
5
7,(b)
I5JB0B1A0028-02