Gear Shift Lever Front Case Assembly Inspection; Engine Rear Mounting Replacement; Manual Transmission Assembly Dismounting And Remounting - Suzuki Grand Vitara 2011 Manual

Gear Shift Lever Front Case Assembly
Inspection
• Check that gear shift shaft moves smoothly without
abnormal noise. If abnormality is found, replace
defective part.
• Check bushes and boot for damage and deterioration.
If abnormality is found, replace defective part.

Engine Rear Mounting Replacement

When replacement of mounting parts are necessary,
torque bolts as specified below.
Tightening torque
Engine rear mounting No.1 bolt (a): 55 N·m (5.5 kgf-
m, 40.0 lb-ft)
Engine rear mounting member bolt (b): 55 N·m (5.5
kgf-m, 40.0 lb-ft)
Engine rear mounting No.2 bolt (c): 55 N·m (5.5 kgf-
m, 40.0 lb-ft)
1. Engine rear mounting member
2. Engine rear mounting
Manual Transmission/Transaxle: For Petrol Engine Model 5B-16
Manual Transmission Assembly Dismounting
and Remounting
S6JB0A5216016
Dismounting
1) Disconnect negative (–) cable of battery.
2) Remove transmission shift control lever referring to
"Transmission Shift Control Lever Removal and
Installation: For Petrol Engine Model".
3) Detach engine harness clamps and ground wire
harness from transmission front case.
S6JB0A5216017
4) Remove starting motor fastening bolts (2) and
transmission fastening bolts (1).
5) Disconnect clutch fluid joint from pipe of clutch
operating cylinder assembly referring to "Clutch
Operating Cylinder Assembly Removal and
Installation in Section 5C".
6) Hoist vehicle.
7) Drain oil from transmission and transfer or extension
case.
8) Remove propeller shafts referring to "Propeller Shaft
Removal and Installation in Section 3D".
9) Remove exhaust No. 2 pipe.
10) Remove engine under cover.
11) Remove clutch housing lower plates (1).
I5JB0A520015-01
1
1
S6JB0A5216018
1
2
I5JB0A520016-01