Suzuki Grand Vitara 2011 Manual page 900

2C-7 Rear Suspension:
9) Remove bump stopper (1) from suspension upper
arm (2) by using special tool (A).
Special tool
(A): 09941–66010
10) Remove bump stopper upper seat bolts (4), and
bump stopper upper seat (3) from body.
4
(A)
Installation
1) Install bump stopper upper seat (1) to body and
tighten bolts (2).
2) Tighten bump stopper (3) to specified torque by
using special tool (A).
Special tool
(A): 09941–66010
Tightening torque
Bump stopper (a): 50 N·m (5.0 kgf-m, 36.5 lb-ft)
2
(A)
3
1
2
I5JB0A230013-01
1
3
I5JB0A230014-01
3) Installing coil spring on lower arm and place coil
spring end (1) onto lower arm (2) as shown.
CAUTION
!
• Flat end coil spring is upward.
• Upper end of coil spring has to be firmly
mated to coil spring rubber seat.
• End of coil spring must not interfere with
step of spring lower seat.
4) Support lower arm (2) with jack (4).
5) Hoist jack and then install lower arm outer bolt (5)
and tighten bolt temporarily by hand.
CAUTION
!
If lower arm outer bolt is reused, apply
engine oil to thread, bearing and trunk
surface.
5
2
"a"
"a": 5 mm
1
2
4
3
I5JB0D230001-02