Suzuki Grand Vitara 2011 Manual page 1464

6B-6 Steering Wheel and Column:
3) Remove steering column cover screws (1) (3
pieces).
4) Separate upper cover (2) and lower cover (3), then
remove them.
2
5) Disconnect all connectors for contact coil cable
assembly.
6) Remove contact coil cable assembly (1) with
steering angle sensor (ESP® model) from steering
column.
7) (ESP® model)
Separate steering angle sensor from contact coil
cable assembly referring to "Steering Angle Sensor
Removal and Installation (ESP® model)".
1
3
1
I5JB0A620012-01
1
I6JB01620002-01
Installation
1) Check to make sure that vehicle's front tires are set
at straight-ahead position and then ignition switch is
at "LOCK" position.
2) (ESP® model)
Install steering angle sensor to contact coil cable
assembly refer to "Steering Angle Sensor Removal
and Installation (ESP® model)".
3) Install contact coil cable assembly to steering
column nothing the following.
• Fit lower fitting part first and then fit upper fitting
part.
NOTE
New contact coil cable assembly is supplied
with contact coil cable assembly set and held
at its center position with a lock pin (1).
Remove this lock pin after installing contact
coil cable assembly to steering column.
4) Connect all connectors that have been removed in
"Removal".
5) Install steering column upper cover (2) and lower
cover (3), and then tighten steering column cover
screws (1).
CAUTION
!
When installing lower cover (3) and upper
cover (2), be careful so that each lead wire is
not caught between covers.
2
*: Standard screw
**: Tapping screw
I5JB0A620014-01
1**
3
1*
I5JB0A620015-01