Suzuki Grand Vitara 2011 Manual page 1498

6C-25 Power Assisted Steering System:
4) Apply power steering fluid to sliding surface of rotor
(1).
5) Install rotor (1) to shaft, directing dot (3) marked side
of rotor facing up.
6) Install new snap ring (2) to shaft, then make sure to
fit snap into shaft groove securely.
NOTE
Never reuse the removed snap ring (2).
2
7) Apply power steering fluid to sliding surface of cam
ring (1).
8) Apply power steering fluid to each vane (2).
9) Install vanes (2) (10 pieces) to rotor (1).
1
10) Apply power steering fluid to O-ring (1).
11) Install O-ring (1) to pump body.
3
1
1
I5JB0A630033-01
2
I5JB0A630034-01
1
I5JB0A630035-01
12) Apply power steering fluid to sliding surface of pump
cover and rotor.
13) Match the dowel pins (1) to the holes of the cover
plate (2) as shown and install pump cover to pump
body.
1
14) Gradually tighten pump cover (1) bolts to diagonally
specified torque.
NOTE
After installing pump cover (1), check to
make sure that shaft can be turned by hand.
Tightening torque
P/S pump cover bolt (a): 28 N·m (2.8 kgf-m, 20.5
lb-ft)
15) Apply power steering fluid to O-ring (2) of pressure
switch.
16) Install O-ring (2) to pressure switch.
17) Install pressure switch (1) to pump body.
Tightening torque
Pressure switch (M16A engine model) (a): 28
N·m (2.8 kgf-m, 20.5 lb-ft)
1, (a)
2
I5JB0A630036-01
IYSQ01630049-01
2
I5JB0A630037-04