Importing And Exporting Zone Sets - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 24 Configuring and Managing Zones
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
Figure 24-5
active zone set mismatch

Importing and Exporting Zone Sets

To import or export the zone set information from or to an adjacent switch, follow these steps:
Command
Step 1
switch# zoneset import interface fc1/3
vsan 2
switch# zoneset import interface fc1/3
vsan 2-5
Step 2
switch# zoneset export vsan 5
switch# zoneset export vsan 5-8
Issue the import and export commands from a single switch. Importing from one switch and exporting
Note
from another switch can lead to isolation again.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Import the neighboring switch's active zone set database and replace the current active zone set (see
Figure 24-5).
Export the current database to the neighboring switch.
Manually resolve the conflict by editing the full zone set, activating the corrected zone set, and then
bringing up the link.
Importing and Exporting the Database
Isolated port due to
Switch 1
From Switch 1, Import
database forces Switch 1
to use the database
configured in Switch 2
From Switch 1, Export
database forces Switch 2
to use the database
configured in Switch 1
Purpose
Imports the zone set from the adjacent switch connected
through the fc 1/3 interface for VSAN 2.
Imports the zone set from the adjacent switch connected
through the fc 1/3 interface for VSANs ranging from 2
through 5.
Exports the zone set to the adjacent switch connected
through VSAN 5.
Exports the zone set to the adjacent switch connected
through the range of VSANs 5 through 8.
Cisco MDS 9000 Family CLI Configuration Guide
Zone Set Distribution
Switch 2
24-15