Default Settings - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Default Settings

D r a f t Ve r s i o n 3 - 0 3 D e c 2 0 0 8 - C i s c o C o n f i d e n t i a l
Example 16-2 Displays the Trunking Protocol
switch# show trunk protocol
Trunk protocol is enabled
Example 16-3 Displays Per VSAN Information on Trunk Ports
switch# show interface trunk vsan 1-1000
fc3/1 is not trunking
...
fc3/7 is trunking
...
fc3/10 is trunking
fc3/11 is trunking
...
port-channel 6 is trunking
Default Settings
Table 16-4
Table 16-4
Parameters
Switch port trunk mode
Allowed VSAN list
Allowed VF-ID list
Trunking protocol on E ports
Trunking protocol on F ports
Cisco MDS 9000 Family CLI Configuration Guide
16-14
Vsan 1000 is down (Isolation due to vsan not configured on peer)
Vsan 1 is up, FCID is 0x760001
Vsan 2 is up, FCID is 0x6f0001
Belongs to port-channel 6
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
lists the default settings for trunking parameters.
Default Trunk Configuration Parameters
Chapter 16
Default
ON on non-NPV and MDS core switches.
OFF on NPV switches.
1 to 4093 user-defined VSAN IDs.
1 to 4093 user-defined VF-IDs.
Enabled.
Disabled.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Configuring Trunking