Configuring The Notification Target User - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

SNMP Trap and Inform Notifications
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To enable individual notifications, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# snmp-server enable traps
fcdomain
switch(config)# no snmp-server enable
traps
You can use the show snmp trap command to display all the notifications and their status.
switch# show snmp trap
Trap type
---------
entity fru
fcc
fcdomain
fcns
fcs request-reject
fcs discovery-complete
fdmi
fspf
license
port-security
rscn els
rscn ils
snmp authentication
vrrp
zone unsupported member
zone request-reject
zone merge-failure
zone merge-success
zone default-zone-behavior-change

Configuring the Notification Target User

You must configure a notification target user on the switch for sending SNMPv3 inform notifications to
the SNMP manager.
To configure the notification target user, use the following command:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# snmp-server user testusr
auth md5 xyub20gh priv xyub20gh engineID
00:00:00:63:00:01:00:a1:ac:15:10:03
switch(config)# no snmp-server user testusr
auth md5 xyub20gh priv xyub20gh engineID
00:00:00:63:00:01:00:a1:ac:15:10:03
The credentials of the notification target user are used for encrypting the SNMPv3 inform notification
messages to the configured SNMP manager (as in the snmp-server host command).
Cisco MDS 9000 Family CLI Configuration Guide
33-12
Purpose
Enters configuration mode.
Enables the specified SNMP (fcdomain) notification.
Disables the specified SNMP notification. If a
notification name is not specified, all notifications are
disabled.
Enabled
-------
Yes
No
No
No
No
No
No
No
Yes
No
No
No
No
Yes
No
No
No
No
No
Purpose
Enters configuration mode.
Configures the notification target user with the
specified credentials for the SNMP manager with
the specified engine ID.
Removes the notification target user.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Chapter 33 Configuring SNMP