Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 164

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enable full zoneset distribution (yes/no) [n]: no
Disables the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
Note
Enter enhanced (basic is the default) to configure default-zone mode as enhanced.
Step 22
Configure default zone mode (basic/enhanced) [basic]: enhanced
Overrides the switch-wide default zone mode as enhanced.
Note
Enter no (no is the default) if you are satisfied with the configuration.
Step 23
The following configuration will be applied:
username admin password admin_pass role network-admin
snmp-server community snmp_community rw
switchname switch
interface vsan1
ip default-gateway default_gateway
no telnet server disable
ssh key rsa 2048 force
ssh server enable
system default switchport shutdown
system default switchport trunk mode auto
system default switchport mode F
no zone default-zone permit vsan 1-4093
no zoneset distribute full vsan 1-4093
system default zone mode enhanced
Would you like to edit the configuration? (yes/no) [n]: no
Enter yes (yes is default) to use and save this configuration.
Step 24
Use this configuration and save it? (yes/no) [y]: yes
Caution
Cisco MDS 9000 Family CLI Configuration Guide
5-14
If you are executing the setup script after issuing a write erase command, you must explicitly
change the default zone policy to permit for VSAN 1 after finishing the script using the
following commands:
switch# config t
switch(config)# zoneset distribute full vsan 1
If you are executing the setup script after issuing a write erase command, you must explicitly
change the default zoning mode to enhanced for VSAN 1 after finishing the script using the
following commands:
switch# config t
switch(config)# zone mode enhanced vsan 1
ip address ip_address subnet_mask
no shutdown
If you do not save the configuration at this point, none of your changes are updated the next
time the switch is rebooted. Type yes to save the new configuration. This ensures that the
kickstart and system images are also automatically configured (see
Images").
Chapter 5 Initial Configuration
Chapter 8, "Software
OL-18084-01, Cisco MDS NX-OS Release 4.x