Configuring Allowed Domain Id Lists; About Cfs Distribution Of Allowed Domain Id Lists; Enabling Distribution - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 18 Configuring Domain Parameters
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring Allowed Domain ID Lists

To configure the allowed domain ID list, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# fcdomain allowed 50-110 vsan 4
switch(config)# no fcdomain allowed 50-110 vsan 5

About CFS Distribution of Allowed Domain ID Lists

You can enable the distribution of the allowed domain ID lists configuration information to all Cisco
MDS switches in the fabric using the Cisco Fabric Services (CFS) infrastructure. This feature allows you
to synchronize the configuration across the fabric from the console of a single MDS switch. Since the
same configuration is distributed to the entire VSAN, you avoid possible misconfiguration and the
likelihood that two switches in the same VSAN have configured incompatible allowed domains.
All switches in the fabric must be running Cisco SAN-OS Release 3.0(1) or later to distribute the allowed
Note
domain ID list using CFS.
Use CFS to distribute the allowed domain ID list to ensure consistency in the allowed domain ID lists
on all switches in the VSAN.
We recommend configuring the allow domain ID list and committing it on the principle switch.
Note
For more information about CFS, see

Enabling Distribution

CFS distribution of allowed domain ID lists is disabled by default. You must enable distribution on all
switches to which you want to distribute the allowed domain ID lists.
To enable (or disable) allowed domain ID list configuration distribution, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# fcdomain distribute
switch(config)# no fcdomain distribute
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Enters configuration mode.
Configures the list to allow switches with
the domain ID 50 through 110 in VSAN 4.
Reverts to the factory default of allowing
domain IDs from 1 through 239 in VSAN 5.
Chapter 7, "Using the CFS Infrastructure."
Purpose
Enters configuration mode.
Enables domain configuration distribution.
Disables (default) domain configuration
distribution.
Cisco MDS 9000 Family CLI Configuration Guide
Domain IDs
18-11