Clearing The Time Stamp; Configuring Snmp Control Of Ficon Parameters - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 29 Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To configure host control of the timestamp, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ficon vsan 2
switch(config-ficon)#
Step 3
switch(config-ficon)# no host
set-timestamp
switch(config-ficon)# host set-timestamp

Clearing the Time Stamp

You can clear time stamps only from the Cisco MDS switch—not the mainframe.
Note
Use the clear ficon vsan vsan-id timestamp command in EXEC mode to clear the VSAN clock.
switch# clear ficon vsan 20 timestamp

Configuring SNMP Control of FICON Parameters

By default, SNMP users can configure FICON parameters through the Cisco MDS 9000 Family Fabric
Manager.
If you disable SNMP in the Cisco MDS switch, you cannot configure FICON parameters using the Fabric
Note
Manager.
To configure SNMP control of FICON parameters, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ficon vsan 2
switch(config-ficon)#
Step 3
switch(config-ficon)# no snmp port
control
switch(config-ficon)# snmp port control
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Enters configuration mode.
Enables FICON on VSAN 2.
Prohibits mainframe users from changing the
VSAN-specific clock.
Allows the host to set the clock on this switch
(default).
Purpose
Enters configuration mode.
Enables FICON on VSAN 2.
Prohibits SNMP users from configuring FICON
parameters.
Allows SNMP users to configure FICON parameters
(default).
Cisco MDS 9000 Family CLI Configuration Guide
Configuring FICON
29-21