Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 173

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To configure NTP in a server association using DNS names, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# ntp server NtpServer
Step 3
switch(config)# ntp peer NtpPeer
Step 4
switch(config)# exit
switch#
Step 5
switch# copy running-config startup-config
Step 6
switch# show ntp peers
This example shows the NTP Peers:
switch# show ntp peers
--------------------------------------------
Peer IP Address
--------------------------------------------
NtpPeer
NtpServer
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Enters configuration mode.
Forms a server association with a server.
Forms a peer association with a peer. You can
specify multiple associations.
Returns to EXEC mode.
Saves your configuration changes to NVRAM.
Tip
Displays the configured server and peer
associations.
Serv/Peer
Peer (configured)
Server (configured)
Cisco MDS 9000 Family CLI Configuration Guide
NTP Configuration
This is one instance where you can save
the configuration as a result of an NTP
configuration change. You can issue this
command at any time.
5-23