Deleting A Schedule Time; Verifying The Command Scheduler Execution Status; Execution Logs; About Execution Logs - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 19 Scheduling Maintenance Jobs
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Deleting a Schedule Time

To delete the schedule time, follow these steps:
Command
Step 1
switch# conf t
switch(config)#
Step 2
switch(config)# scheduler schedule
name weekendbackupqos
switch(config-schedule)#
Step 3
switch(config-schedule)# no time

Verifying the Command Scheduler Execution Status

To verify the command scheduler execution status, use the show scheduler schedule command.
switch# show scheduler schedule configureVsan99
Schedule Name
------------------------------------
User Name
Schedule Type
Last Execution Time: Tue Aug 10 09:48:00 2004
-----------------------------------------------
-----------------------------------------------
addMemVsan99

Execution Logs

This section describes execution logs for the command scheduler and contains the following sections:
•
•
•

About Execution Logs

The command scheduler maintains a log file. While you cannot modify the contents of this file, you can
change the file size. This log file is a circular log that contains the output of the job executed. If the
output of the job is greater than the log file, then the output stored in this file remains truncated.
You can configure the log file size to be a maximum of 1024 KB. The default size of the execution log
file is 16 KB.
OL-18084-01, Cisco MDS NX-OS Release 4.x
: configureVsan99
: admin
: Run once on Tue Aug 10 09:48:00 2004
Job Name
About Execution Logs, page 19-9
Configuring Execution Logs, page 19-10
Clearing the Execution Log File Contents, page 19-10
Purpose
Enters the configuration mode.
Defines a job schedule (weekendbackup) and enters the
submode for that schedule.
Deletes the schedule time configuration.The schedule
will not be run until the time is configured again.
Status
Success (0)
Cisco MDS 9000 Family CLI Configuration Guide
Execution Logs
19-9