Configuring System Default Zoning Settings; Displaying Enhanced Zone Information - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 24 Configuring and Managing Zones
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 5
switch(config-zone)# member pwwn
21:00:00:e0:8b:0b:66:56
switch(config-zone)# member pwwn
21:01:00:e0:8b:2e:80:93
switch(config-zone)# attribute-group name
BroadcastAttr
switch(config-zone)# exit
switch(config)#
Step 6
switch(config)# zone commit vsan 1
Commit operation initiated
switch(config)# end
Step 7
switch# show zone vsan 1
zone name BroadcastAttr vsan 1
zone-attribute-group name BroadcastAttr vsan 1
broadcast
pwwn 21:00:00:e0:8b:0b:66:56
pwwn 21:01:00:e0:8b:2e:80:93

Configuring System Default Zoning Settings

You can configure default settings for default zone policies and full zone distribution for new VSANs on
the switch. To configure switch-wide default settings, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# system default zone default-zone
permit
switch(config)# no system default zone
default-zone permit
Step 3
switch(config)# system default zone distribute
full
Step 4
switch(config)# no system default zone distribute
full
Since VSAN 1 is the default VSAN and is always present on the switch, the system default zone
Note
commands have no effect on VSAN 1.

Displaying Enhanced Zone Information

You can view any zone information by using the show command. See Examples
Example 24-20 Displays the Active Zone Set Information for a Specified VSAN
switch# show zoneset active vsan 2
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Adds the specified members to this zone and
exits this submode.
Applies the changes to the enhanced zone
configuration and exits this submode.
Displays the broadcast configuration
Purpose
Enters configuration mode.
Configures permit as the default zoning
policy for new VSANs on the switch.
Configures deny (default) as the default
zoning policy for new VSANs on the
switch.
Enables full zone database distribution as
the default for new VSANs on the switch.
Disables (default) full zone database
distribution as the default for new VSANs
on the switch. Only the active zone
database is distributed.
Cisco MDS 9000 Family CLI Configuration Guide
Enhanced Zoning
24-20 to 24-32.
24-37