Verifying The Ssi Boot Image - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Upgrading the SSI Boot Image
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To upgrade or downgrade the SSI boot image Fibre Channel switching and Intelligent Storage Services,
perform the following steps:
Verify that the correct SSI boot image is present on your switch (see the
Step 1
section on page
Update the SSI boot image using one of the following methods:
Step 2
a.
b.

Verifying the SSI Boot Image

To verify that you have the correct Cisco MDS NX-OS release and SSI boot image file on your switch,
perform the following steps:
Log into the switch through the console port, an SSH session, or a Telnet session.
Step 1
Enter the show version command to ensure that your switch is running Cisco MDS SAN-OS Release
Step 2
2.1(1a) or later system and kickstart images.
switch# show version
Cisco Nexus Operating System (NX-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2009, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software may be covered under the GNU Public
License or the GNU Lesser General Public License. A copy of
each such license is available at
http://www.gnu.org/licenses/gpl.html and
http://www.gnu.org/licenses/lgpl.html
Software
BIOS:
loader:
kickstart: version 2.1(2) [build 2.1(2.47)] [gdb]
system:
...
If necessary, upgrade the Cisco MDS SAN-OS or NX-OS software running on your switch (see the
Step 3
"Software Upgrade Methods" section on page
Cisco MDS 9000 Family CLI Configuration Guide
12-20
12-20).
If your switch is running Cisco MDS SAN-OS Release 2.0(1a) through Release 2.1(1a), configure
the SSI boot variable to upgrade or downgrade the SSI boot image on the module (see the
"Configuring the SSI Image Boot Variable" section on page
Use the install ssi command to upgrade or downgrade the SSI boot image on the module (see the
"Using the install ssi Command" section on page
The SSM must be running EPLD version 2.1(2) to use the install ssi command. You must
Note
install the SSM on a Cisco MDS 9500 Series switch to upgrade the EPLD. See the
Configuration" section on page
version 1.0.8
version unavailable [last: 1.0(0.267c)]
version 2.1(2) [build 2.1(2.47)] [gdb]
12-23).
12-25).
12-12.
8-5).
OL-18084-01, Cisco MDS NX-OS Release 4.x
Chapter 12 Managing Modules
"Verifying the SSI Boot Image"
"EPLD