Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 1113

Chapter 43 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
Figure 43-21
o.01.255891611111
.01.25589167F74C
To configure scenario 1 (see
Configure null authentication for all iSCSI hosts in Cisco MDS switches.
Step 1
switch(config)# iscsi authentication none
Step 2 Configure iSCSI to dynamically import all Fibre Channel targets into the iSCSI SAN using
auto-generated iSCSI target names.
switch(config)# iscsi import target fc
Configure the Gigabit Ethernet interface in slot 7 port 1 with an IPv4 address and enable the interface.
Step 3
switch(config)# interface gigabitethernet 7/1
switch(config-if)# ip address 10.11.1.1 255.255.255.0
switch(config-if)# no shutdown
Note
OL-18084-01, Cisco MDS NX-OS Release 4.x
No LUN mapping or LUN masking or any other access control for hosts on the target device
No iSCSI login authentication (that is, login authentication set to none)
The topology is as follows:
iSCSI interface 7/1 is configured to identify initiators by IP address.
–
iSCSI interface 7/5 is configured to identify initiators by node name.
–
The iSCSI initiator host 1 with IPv4 address 10.11.1.10 and name
–
iqn.1987-05.com.cisco:01.255891611111 connects to IPS port 7/1 is identified using IPv4
address (host 1 = 10.11.1.10).
– The iSCSI initiator host 2 with IPv4 address 10.15.1.10 and node name
iqn.1987-05.com.cisco:01.25589167f74c connects to IPS port 7/5.
iSCSI Scenario 1
Host 1
10.11.1.10
iSCSI
10.15.1.10
iSCSI
Host 2
7/5
Figure
Host 2 is connected to this port.
7/1
iSCSI-zone-1
Switch 1
iSCSI-zone-2
43-21), follow these steps:
Cisco MDS 9000 Family CLI Configuration Guide
iSCSI Authentication Setup Guidelines and Scenarios
Interface fc 2/1
21:00:00:20:37:6f:fd:97
Interface fc 2/5
21:00:00:20:37:6f:fe:54
Interface fc 2/9
21:00:00:20:37:a6:a6:5d
43-69