DHCHAP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
About Enabling DHCHAP
By default, the DHCHAP feature is disabled in all switches in the Cisco MDS 9000 Family.
You must explicitly enable the DHCHAP feature to access the configuration and verification commands
for fabric authentication. When you disable this feature, all related configurations are automatically
discarded.
Enabling DHCHAP
To enable DHCHAP for a Cisco MDS switch, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# feature fcsp
switch(config)# no feature fcsp
Cisco MDS 9000 Family CLI Configuration Guide
38-4
Chapter 38
Purpose
Enters configuration mode.
Enables the DHCHAP in this switch.
Disables (default) the DHCHAP in this switch.
Configuring FC-SP and DHCHAP
OL-18084-01, Cisco MDS NX-OS Release 4.x