Configuring A Lun-Based Zone - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Advanced Zone Attributes
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
When LUN 0 is not included within a zone, then, as per standards requirements, control traffic to LUN
Note
0 (for example, REPORT_LUNS, INQUIRY) is supported, but data traffic to LUN 0 (for example,
READ, WRITE) is denied.
•
•
Unzoned LUNs automatically become members of the default zone.
Note
Figure 24-8
Figure 24-8

Configuring a LUN-Based Zone

To configure a LUN-based zone, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# zone name LunSample vsan 2
switch(config-zone)#
Step 3
switch(config-zone)# member pwwn
10:00:00:23:45:67:89:ab lun 0x64
switch(config-zone)# member fcid 0x12465
lun 0x64
Cisco MDS 9000 Family CLI Configuration Guide
24-22
Host H1 can access LUN 2 in S1 and LUN 0 in S2. It cannot access any other LUNs in S1 or S2.
Host H2 can access LUNs 1 and 3 in S1 and only LUN 1 in S2. It cannot access any other LUNs in
S1 or S2.
shows a LUN-based zone example.
LUN Zoning Access
H1
Zone 1
Zone 2
H2
Zone 2
Fabric
Purpose
Enters configuration mode.
Configures a zone called LunSample for the
specified VSAN (vsan 2) and enters zone
configuration submode.
Configures a zone member based on the specified
pWWN and LUN value.
Note
Configures a zone member based on the FC ID and
LUN value.
Chapter 24 Configuring and Managing Zones
S1
LUN 0
LUN 1
LUN 2
S1 LUN 3
LUN 0
LUN 1
LUN 2
S2
LUN 3
The CLI interprets the LUN identifier value
as a hexadecimal value whether or not the
0x prefix is included. LUN 0x64 in hex
format corresponds to 100 in decimal
format.
OL-18084-01, Cisco MDS NX-OS Release 4.x