About Ficon Configuration Files; Applying The Saved Configuration Files To The Running Configuration; Editing Ficon Configuration Files - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 29 Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
See the
used by Cisco MDS switches.
This section includes the following topics:
•
•
•
•
•

About FICON Configuration Files

Only one user can access the configuration file at any given time:
•
•
•
FICON configuration files can be accessed by any host, SNMP, or CLI user who is permitted to access
the switch. The locking mechanism in the Cisco NX-OS software restricts access to one user at a time
per file. This lock applies to newly created files and previously saved files. Before accessing any file,
you must lock the file and obtain the file key. A new file key is used by the locking mechanism for each
lock request. The key is discarded when the lock timeout of 15 seconds expires. The lock timeout value
cannot be changed.

Applying the Saved Configuration Files to the Running Configuration

You can apply the configuration from the saved files to the running configuration using the ficon vsan
number apply file filename command.
switch# ficon vsan 2 apply file SampleFile

Editing FICON Configuration Files

The configuration file submode allows you to create and edit FICON configuration files. If a specified
file does not exist, it is created. Up to 16 files can be saved. Each file name is restricted to eight
alphanumeric characters.
To edit the contents of a specified FICON configuration file, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ficon vsan 2
switch(config-ficon)#
OL-18084-01, Cisco MDS NX-OS Release 4.x
"Managing Configuration Files" section on page 9-1
About FICON Configuration Files, page 29-33
Applying the Saved Configuration Files to the Running Configuration, page 29-33
Editing FICON Configuration Files, page 29-33
Displaying FICON Configuration Files, page 29-34
Copying FICON Configuration Files, page 29-35
If this file is being accessed by user 1, user 2 cannot access this file.
If user 2 does attempt to access this file, an error is issued to user 2.
If user 1 is inactive for more than 15 seconds, the file is automatically closed and available for use
by any other permitted user.
for details on the normal configuration files
Purpose
Enters configuration mode.
Enables FICON on VSAN 2.
Cisco MDS 9000 Family CLI Configuration Guide
FICON Configuration Files
29-33