Default Settings - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 12 Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Default Settings

Table 12-10
Table 12-10
Parameters
Administrative connection
Global switch information
System clock
In-band (VSAN 1) interface
OL-18084-01, Cisco MDS NX-OS Release 4.x
Install is in progress, please wait.
Module 6:Force downloading.
-- SUCCESS
Syncing image bootflash:/SSI-2.1.1a to standby.
[####################] 100% -- SUCCESS
Syncing image bootflash:/boot-2-1-1a to standby.
[####################] 100% -- SUCCESS
Syncing image bootflash:/isan-2-1-1a to standby.
[####################] 100% -- SUCCESS
Setting boot variables.
[####################] 100% -- SUCCESS
Performing configuration copy.
[####################] 100% -- SUCCESS
Module 3:Upgrading Bios/loader/bootrom.
[####################] 100% -- SUCCESS
Module 6:Waiting for module online.
-- SUCCESS
"Switching over onto standby".
-----------------------------
lists the default settings for the supervisor module.
Default Supervisor Module Settings
Default
Serial connection.
No value for system name.
•
No value for system contact.
•
No value for location.
•
No value for system clock time.
IP address, subnet mask, and broadcast address assigned to the
VSAN are set to 0.0.0.0.
Cisco MDS 9000 Family CLI Configuration Guide
Default Settings
12-31