Manually Enabling Ficon On A Vsan - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
`zone default-zone permit vsan 2`
`ficon vsan 2`
`no host port control`
`no active equals saved`
Note
`vsan database`
`vsan 3`
`in-order-guarantee vsan 3`
`fcdomain domain 2 static vsan 3`
`fcdomain restart disruptive vsan 3`
`fabric-binding activate vsan 3 force`
`zone default-zone permit vsan 3`
`ficon vsan 3`
`no snmp port control`
Performing fast copy config...done.
switch#

Manually Enabling FICON on a VSAN

This section describes the procedure to manually enable FICON on a VSAN. If you have already enabled
Note
FICON on the required VSAN using the automated setup (recommended), skip to the
Saving the Running Configuration" section on page
To manually enable FICON on a VSAN, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# vsan database
switch(config-vsan-db)# vsan 5
switch(config-vsan-db)# do show vsan usage
4 vsan configured
configured vsans:1-2,5,26
vsans available for configuration:3-4,6-25,27-4093
switch(config-vsan-db)# exit
Step 3
switch(config)# in-order-guarantee vsan 5
Step 4
switch(config)# fcdomain domain 2 static vsan 2
Cisco MDS 9000 Family CLI Configuration Guide
29-18
If a new VSAN is created, two additional commands are displayed— vsan database and vsan
number.
Chapter 29
29-22.
Purpose
Enters configuration mode.
Enables VSAN 5.
Activates in-order delivery for VSAN 5.
See Chapter 26, "Configuring Fibre
Channel Routing Services and
Protocols."
Configures the domain ID for VSAN 2.
See Chapter 18, "Configuring Domain
Parameters."
OL-18084-01, Cisco MDS NX-OS Release 4.x
Configuring FICON
"Automatically