Iscsi Listener Port; Tcp Tuning Parameters - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Cisco mds 9000 family cli configuration guide - release 4.x (ol-18084-01, february 2009)
Hide thumbs Also See for AP776A - Nexus Converged Network Switch 5020:
Table of Contents

Advertisement

Chapter 43
Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To access these commands from the iSCSI interface, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface iscsi 4/1
switch(config-if)#
Cisco MDS switches support the following advanced features for iSCSI interfaces:

iSCSI Listener Port

You can configure the TCP port number for the iSCSI interface that listens for new TCP connections.
The default port number is 3260. Once you change the TCP port number, the iSCSI port only accepts
TCP connections on the newly configured port.

TCP Tuning Parameters

You can configure the following TCP parameters:
OL-18084-01, Cisco MDS NX-OS Release 4.x
iSCSI Listener Port, page 43-27
TCP Tuning Parameters, page 43-27
QoS, page 43-28
iSCSI Routing Modes, page 43-28
Minimum retransmit timeout (See the
Keepalive timeout (See the
Maximum retransmissions (See the
Path MTU (See the
"Path MTUs" section on page
SACK (SACK is enabled by default for iSCSI TCP configurations.)
Window management (The iSCSI defaults are max-bandwidth is 1 Gbps, min-available-bandwidth
is 70 Mbps, and round-trip-time is 1 msec.) (See the
page
41-15.)
Buffer size (The iSCSI default send buffer size is 4096 KB) (See the
page
41-17.)
Window congestion monitoring (enabled by default and the default burst size is 50 KB) (See the
"Monitoring Congestion" section on page
Maximum delay jitter (enabled by default and the default time is 500 microseconds)
Purpose
Enters configuration mode.
Selects the iSCSI interface on the switch.
"Minimum Retransmit Timeout" section on page
"Keepalive Timeout" section on page
"Maximum Retransmissions" section on page
41-14.)
41-15.)
Cisco MDS 9000 Family CLI Configuration Guide
41-13.)
"Window Management" section on
"Buffer Size" section on
Configuring iSCSI
41-13.)
41-14)
43-27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents