Scope Of Link Up/Down Trap Settings; Displaying Snmp Security Information - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 33 Configuring SNMP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
...
To view the SNMP link-state trap configuration for a particular interface, enter the show interface
command.
switch# show interface bay 6
bay6 is down (Administratively down)

Scope of Link Up/Down Trap Settings

The link Up/Down trap settings for the interfaces generate traps based on the following scope:
Switch-level Trap Setting
Enabled (defualt)
Enabled
Disabled
Disabled

Displaying SNMP Security Information

Use the show snmp commands to display configured SNMP information (see
Example 33-1 Displays SNMP User Details
switch# show snmp user
______________________________________________________________
______________________________________________________________
User
____
admin
testusr
______________________________________________________________
OL-18084-01, Cisco MDS NX-OS Release 4.x
Hardware is Fibre Channel
Port WWN is 20:0b:00:05:30:01:70:2c
Admin port mode is auto, trunk mode is on
snmp link-state traps are disabled
Port vsan is 1
Receive data field Size is 2112
Beacon is turned off
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
0 frames input, 0 bytes
0 discards, 0 errors
0 CRC, 0 unknown class
0 too long, 0 too short
0 frames output, 0 bytes
0 discards, 0 errors
0 input OLS, 0 LRR, 0 NOS, 0 loop inits
0 output OLS, 0 LRR, 0 NOS, 0 loop inits
SNMP USERS
Interface-level Trap Setting
Enabled (default)
Disabled
Enabled
Disabled
Auth Priv(enforce) Groups
____ _____________ ______
md5 des(no) network-admin
md5 aes-128(no) role111
role222
Cisco MDS 9000 Family CLI Configuration Guide
SNMP Trap and Inform Notifications
Trap Generated for Interface Links?
Yes
No
No
No
Example 33-1 and 33-6).
33-15