About Ficon Device Allegiance; Clearing Ficon Device Allegiance; Automatically Saving The Running Configuration - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

About FICON Device Allegiance

FICON requires serialization of access among multiple mainframes, CLI, and SNMP sessions be
maintained on Cisco MDS 9000 Family switches by controlling device allegiance for the currently
executing session. Any other session is denied permission to perform configuration changes unless the
required allegiance is available.
This task discards the currently executing session.
Caution

Clearing FICON Device Allegiance

You can clear the current device allegiance by issuing the clear ficon vsan vsan-id allegiance command
in EXEC mode.
switch# clear ficon vsan 1 allegiance

Automatically Saving the Running Configuration

Cisco MDS NX-OS provides an option to automatically save any configuration changes to the startup
configuration. This ensures that the new configuration is present after a switch reboot. The active equals
saved option can be enable on any FICON VSAN.
Table 29-2
running-config startup-config command in various scenarios.
If the active equals saved is enabled in any FICON-enabled VSAN in the fabric, then the following
apply (see Number
•
•
If the active equals saved is not enabled in any FICON-enabled VSAN in the fabric, then
FICON-specific configuration changes are not saved in the IPL file and an implicit copy running
startup command is not issued, you must issue the copy running start command explicitly (see number
3 in
Table 29-2 Saving the Active FICON and Switch Configuration
FICON-
enabled
active equals saved
Number VSAN? Enabled?
1 Yes Yes (in all FICON
VSANs)
Cisco MDS 9000 Family CLI Configuration Guide
29-22
displays the results of the active equals saved command and the implicit copy
1 and 2 in
All configuration changes (FICON-specific or not) are automatically saved to persistent storage
(implicit copy running start) and stored in the startup configuration.
FICON-specific configuration changes are immediately saved to the IPL file (see the
Configuration Files" section on page
Table 29-2).
1
Implicit
copy running start
Issued?
Implicit
Table 29-2):
29-32).
Notes
FICON changes written to the IPL file.
Non-FICON changes saved to startup configuration and
persistent storage.
Chapter 29 Configuring FICON
"FICON
OL-18084-01, Cisco MDS NX-OS Release 4.x