Binding Port Numbers To Portchannels; Binding Port Numbers To Fcip Interfaces; Configuring Port Blocking - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Configuring FICON Ports
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•
•
•

Binding Port Numbers to PortChannels

All port number assignments to PortChannels or FCIP interfaces are lost (cannot be retrieved) when
Caution
FICON is disabled on all VSANs.
You can bind (or associate) a PortChannel with a FICON port number to bring up that interface.
To bind a PortChannel with a FICON port number, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface Port-channel 1
switch(config-if)#
Step 3
switch(config-if)# ficon portnumber 234

Binding Port Numbers to FCIP Interfaces

You can bind (or associate) an FCIP interface with a FICON port number to bring up that interface.
To bind an FCIP interface with a FICON port number, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch1(config)# interface fcip 51
switch1(config-if)#
Step 3
switch(config-if)# ficon portnumber 208

Configuring Port Blocking

If you block a port, the port is retained in the operationally down state. If you unblock a port, a port
initialization is attempted. When a port is blocked, data and control traffic are not allowed on that port.
Physical Fibre Channel port blocks will continue to transmit an Off-line state (OLS) primitive sequence
on a blocked port.
Cisco MDS 9000 Family CLI Configuration Guide
29-24
Port Prohibiting, page 29-25
Assigning a Port Address Name, page 29-26
About RLIR, page 29-27
Specifying an RLIR Preferred Host, page 29-27
Displaying RLIR Information, page 29-28
Clearing RLIR Information, page 29-32
Purpose
Enters configuration mode.
Enters the PortChannel interface configuration mode.
Assigns the FICON port number to the selected
PortChannel port.
Purpose
Enters configuration mode.
Creates an FCIP interface (51).
Assigns the FICON port number to the selected FCIP
interface.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Chapter 29 Configuring FICON