Configuring Dead Time Intervals; About Retransmitting Intervals; Configuring Retransmitting Intervals; About Disabling Fspf For Specific Interfaces - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

FSPF Interface Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
An error is reported at the command prompt if the configured dead time interval is less than the hello
Caution
time interval.

Configuring Dead Time Intervals

To configure the FSPF dead time interval, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface fc1/4
switch(config-if)#
Step 3
switch(config-if)# fspf dead-interval 25
vsan 7
switch(config-if)#

About Retransmitting Intervals

You can specify the time after which an unacknowledged link state update should be transmitted on the
interface. The integer value to specify retransmit intervals can range from 1 to 65,535 seconds.
Note This value must be the same on the switches on both ends of the interface.

Configuring Retransmitting Intervals

To configure the FSPF retransmit time interval, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface fc1/4
switch(config-if)#
Step 3
switch(config-if)# fspf retransmit-interval
15 vsan 12
switch(config-if)#

About Disabling FSPF for Specific Interfaces

You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and
TE ports. This default can be disabled by setting the interface as passive.
Cisco MDS 9000 Family CLI Configuration Guide
26-8
Chapter 26 Configuring Fibre Channel Routing Services and Protocols
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
Specifies the maximum interval for VSAN 7 before
which a hello message must be received on the
selected interface before the neighbor is considered
lost. The default is 80 seconds.
Purpose
Enters configuration mode.
Configures the specified interface, or if already
configured, enters configuration mode for the
specified interface.
Specifies the retransmit time interval for
unacknowledged link state updates in VSAN
12. The default is 5 seconds.
OL-18084-01, Cisco MDS NX-OS Release 4.x