Verifying Com1 Port Settings; Configuring Modem Connections - Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 6
switch(config-com1)# parity
none
Step 7
switch(config-com1)# no
flowcontrol hardware

Verifying COM1 Port Settings

Use the show line com1 command to verify the configured COM1 settings. This command also displays
problems that may have occurred along with the other registration statistics.
The following example displays output from an MDS switch with a Supervisor-1 module:
switch# show line com1
line Aux:
The following example displays output from an MDS switch with a Supervisor-2 module:
switch# show line com1
line Aux:

Configuring Modem Connections

Modems can only be configured if you are connected to the console or COM1 ports. A modem
connection to a switch in the Cisco MDS 9000 Family does not affect switch functionality.
Note If you plan on connecting a modem to the console port or the COM1 port of a switch in the Cisco MDS
9000 Family, refer to the Cisco MDS 9500 Series Hardware Installation Guide or the Cisco MDS 9200
Series Hardware Installation Guide. COM1 ports are not available on switches in the Cisco MDS 9100
Series. Refer to the Cisco MDS 9100 Series Hardware Installation Guide.
OL-18084-01, Cisco MDS NX-OS Release 4.x
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATQ0V1H0S0=1\015
Statistics: tx:17
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q0V1&D0&C0S0=1\015
Statistics: tx:17
Description
Configures the parity for the COM1 connection. The default is no
parity and the valid values are even or odd parity.
Disables hardware flow control. By default, hardware flow
control is enabled on all switches in the Cisco 9000 Family.
When enabled, this option is useful in protecting data loss at
higher baud rates.
This option is only available through the COM1 port.
Note
rx:0 Register Bits:RTS|DTR
rx:0 Register Bits:RTS|DTR
Cisco MDS 9000 Family CLI Configuration Guide
Configuring Modem Connections
5-31