Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 158

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
b.
c.
d.
e.
f.
Enter yes (no is the default) to enable the Telnet service.
Step 13
Enable the telnet service? (yes/no) [y]: yes
Enter yes (yes is the default) to enable the SSH service.
Step 14
Enabled SSH service? (yes/no) [n]: yes
Cisco MDS 9000 Family CLI Configuration Guide
5-8
Continue with in-band (VSAN1) management configuration? (yes/no) [no]: no
Enter yes (yes is the default) to enable IPv4 routing capabilities.
Enable the ip routing? (yes/no) [y]: yes
Enter yes (yes is the default) to configure a static route (recommended).
Configure static route: (yes/no) [y]: yes
Enter the destination prefix.
Destination prefix: dest_prefix
Type the destination prefix mask.
Destination prefix mask: dest_mask
Type the next hop IP address.
Next hop ip address: next_hop_address
Note Be sure to configure the IP route, the default network IP address, and the default gateway IP
address to enable SNMP access. If IP routing is enabled, the switch uses the IP route and the
default network IP address. If IP routing is disabled, the switch uses the default gateway IP
address.
Enter yes (yes is the default) to configure the default network (recommended).
Configure the default network: (yes/no) [y]: yes
Enter the default network IPv4 address.
The default network IPv4 address is the destination prefix provided in
Note
Default network IP address [dest_prefix]: dest_prefix
Enter yes (yes is the default) to configure the DNS IPv4 address.
Configure the DNS IP address? (yes/no) [y]: yes
Enter the DNS IP address.
DNS IP address: name_server
Enter yes (default is no) to configure the default domain name.
Configure the default domain name? (yes/no) [n]: yes
Enter the default domain name.
Default domain name: domain_name
Chapter 5 Initial Configuration
Step 12c .
OL-18084-01, Cisco MDS NX-OS Release 4.x