Sending The Site Configuration To The Ciu 888; Generating The Ini Files; Starting Entis Pro And Reloading Ini Files In Entis Pro; Using Entis As A Host - Honeywell CIU 888 Configuration Manual

NOTE: In case of updating redundant CIU 888, the configuration should be sent to
NOTE: If the CIU 888 does not feature the option to be sealed, the W&M lock key
Part No.: 4417584_Rev12
Updating CIU 888 Site configuration

6.4 Sending the site configuration to the CIU 888

When the site configuration is set up, send the site configuration to the
CIU 888 using the CIU 888 Service Tool, see section 3.3.
Primary CIU 888.

6.5 Generating the INI files

When the site configuration is sent to CIU 888, the next step is to
generate the INI files needed for Entis Pro. Refer to section 3.4 for
detailed information about generating INI files using Service Tool.

6.6 Starting Entis Pro and reloading INI files in Entis Pro

When the INI files have been generated, then start the Entis Pro system
connected to the CIU 888 and then load the INI files in Entis Pro. Refer
to the Configuration manual Entis Pro version 2.80x for Windows 10
(Part No. 4416381) for more information.

6.6.1 Using Entis as a host

To use Entis as a host, refer to the Entis Manuals in Honeywell Entis
HUB accessible from https://process.honeywell.com/us/en/products/
terminals/enraf-tank-gauging/entis-tank-inventory-system

6.7 Verifying the working of the CIU 888 system setup

The final step in the procedure for updating the CIU 888 system setup is
verifying if the system setup is working properly. See section 4.10 for
more information.

6.8 Sealing the CIU 888

If the CIU 888 features the option to be sealed, the next step is to have
it sealed by a representative of the LM authorities or by a LM accredited
user. Refer to the CIU 888 Sealing Guide (Part No. 4417595) for more
information.
switch can either be locked or left unlocked.
Configuration Manual
CIU 888 6 - 3