Chapter 6 Updating Ciu 888 Site Configuration; Requirements For Updating The Non Redundant Ciu 888 Site Configuration - Honeywell CIU 888 Configuration Manual

CHAPTER 6 UPDATING CIU 888 SITE CONFIGURATION

Part No.: 4417584_Rev12
Updating CIU 888 Site configuration
If there are changes in the CIU 888 system setup, these changes must
be implemented in the site configuration. Subsequently, the updated
site configuration must be sent to the CIU 888 for the changes to
become effective.
Changes in the CIU 888 system setup can be the result of the following.
For example:
Connection of additional tank gauging instruments to the CIU 888

Connection of additional host systems to the CIU 888

Installation of a new CIU 888 license resulting in the expansion of the

features and functionalities of the CIU 888 (e.g. redundancy, support
of a larger number of tanks)
Perform the following steps to update the CIU 888 site configuration:
1. Implement the required changes in the site configuration, see
section 6.3
2. Send the updated site configuration to the CIU 888, see section 6.4
3. Generate the INI files required for Entis Pro, see section 6.5
4. Start the Entis Pro system connected to the CIU 888, and load the
INI files in Entis Pro, see section 6.6
5. Verify the working of the system setup, see section 6.7
6. Seal the CIU 888, see section 6.8
6.1 Requirements for updating the non redundant CIU 888 site config-
uration
The following requirements must be met in order to update the CIU 888
site configuration:
The CIU 888 must be switched on. See section 7.1.1 for more

information.
For LM relevant parameters update, W&M lock key switch and

Configuration lock key switch of the CIU 888 must be in 'unlocked'
position. See section 7.2 for more information.
For non LM parameters update, Configuration lock key switch of the

CIU 888 must be in 'unlocked' position. See section 7.2 for more
information.
A PC/laptop running the CIU 888 Configuration System must be

connected to the Service port or VPN port of the CIU 888 using a
Cat. 5 Ethernet cable (patch or crossover). The Service port is
Configuration Manual
CIU 888 6 - 1