Requirements For Updating The Redundant Ciu 888 Site Configuration; Implementing The Required Changes In The Site Configuration - Honeywell CIU 888 Configuration Manual

FIGURE 6-1
Part No.: 4417584_Rev12
Updating CIU 888 Site configuration
located at the front of the CIU 888 (see FIGURE 6-1). See Chapter 3
for more information about the CIU 888 Configuration System.
CIU 888: Service port
6.2 Requirements for updating the redundant CIU 888 site configura-
tion
The following requirements must be met in order to update the CIU 888
site configuration:
The primary CIU 888 and the secondary CIU 888 must be in sync.

For LM parameters update, W&M lock key switch and Configuration

lock key switch of Primary CIU 888 and Secondary CIU 888 must be
in 'unlocked' position. See section 7.2 for more information.
For non LM parameters update, Configuration lock key switch of

Primary CIU 888 and Secondary CIU 888 must be in 'unlocked'
position. See section 7.2 for more information.
A PC/laptop running the CIU 888 Configuration System must be

connected to the Service port of the CIU 888 using a Cat. 5 Ethernet
cable (patch or crossover). The Service port is located at the front of
the CIU 888 (see FIGURE 6-1). See Chapter 3 for more information
about the CIU 888 Configuration System.

6.3 Implementing the required changes in the site configuration

Perform the following procedure to implement the required changes in
the site configuration:
1. Launch CIU 888 Service Tool (refer to section 3.2.2).
2. Load the applicable CIU 888 site configuration (refer to section 3.7).
3. Navigate through the CIU site nodes and do the required changes. If
any new site nodes are required, create and configure them (refer to
section 3.2.5,
section 3.2.11).
Configuration Manual
CIU 888
section 3.2.6, section 3.2.7, section 3.2.9, and
6 - 2