Honeywell CIU 888 Configuration Manual page 112

Part No.: 4417584_Rev12
Getting Started
7. The G1 node is created and displayed under Tank T1.
You can view or edit these properties.
Properties
DensityCalculationType
P1SensorPosition
P3SensorPosition
HybridMinLevel
CIU Parameter
Device Type
Device Slave ID
Configuration Manual
CIU 888
Description
This parameter indicates the HIMS density calculation
type.
The position of the center of the Liquid Pressure sensor
membrane. This is expressed in m.
The position of the center of the Vapor Pressure sensor
membrane. This is expressed in m.
This value specifies the lowest product level at which
the Observed Density would be calculated.
This indicates the CIU parameter name to which the
scanned TRL/2 field device parameter has to be
mapped. CIU Service tool displays all the CIU Parame-
ters which can be scanned from TRL/2 field devices in a
drop down menu.
This is the TRL/2 field device type. For example,
Emersion Rex, Honeywell TRL/2 Gauge. CIU Service
tool displays all the supported device types in a drop
down menu.
Each TRL/2 device is addressed with a unique slave ID.
That is, when a request is received by a Modbus
device, it checks the TRL/2 slave ID in the request and
if it matches with its configured slave ID, it responds
back, else it skips the request. This indicates the TRL/2
RTU address of the field device.
3 - 82