Honeywell CIU 888 Configuration Manual page 122

3.2.12.4 User defined modbus map - Density Profiles
NOTE: The selected list of entities is shown on the right part of the entities tab, this is
Part No.: 4417584_Rev12
Getting Started
Properties
Type
Size
Scale
Offset
This section helps the user to configure the Density Profiles Modbus
area in CIU 888.
The configurable Density Profile fields and a brief description on each of
them are given in the following table.
Fields
Density Profile Absolute
Start address
Density Profile Record
Interval
referred as 'Selected entities' in the below description.
Configuration Manual
CIU 888
Description
Modbus data type of the entity.
Number of Modbus registers
Scaling factor
Offset value
Description
This indicates the absolute start address of the density
profiles record.
Values are in decimal. Default value is 30000
Configurable when modbus mapping is User Specified.
This indicates the record interval of the density profiles
record.
Values are in decimal. Default value is 320
Configurable when modbus mapping is User Specified.
3 - 92