Honeywell CIU 888 Configuration Manual page 96

Part No.: 4417584_Rev12
Getting Started
Properties
Allow Interface 2 com-
mand
Allow Block gauge
Allow Tank profile
Allow Gauge alarm test
Allow Lock test
Allow Reset gauge
Allow Test gauge
Allow Verify command
Allow Water dip
Allow Interface profile
FlexConn address
Primary Gauge
Wire Compensation
Servo Wire thermal exp.
coeff.
Configuration Manual
CIU 888
Description
Check the option, if allowed (I2; 854, 894, 954 only).
Check the option, if allowed (BL; 811, 854, 894, 954 only).
Check the option, if allowed (TP; 854, 894, 954 only).
Check the option, if allowed (AT; 873 only).
Check the option, if allowed (LT; 811, 854, 894, 954 only).
Check the option, if allowed (RS).
Check the option, if allowed (TG; 811, 854, 894, 954 only).
Check the option, if allowed (CA; 854, 894, 954 only).
Check the option, if allowed (I3; 811, 854, 894, 954 only).
Check the option, if allowed (IP; 854, 894, 954 only).
Set the option, if allowed (954, 990 Only).
This indicates whether the gauge is primary or not. For
primary gauge, all measurements can be enabled for
scan and gauge commands can be enabled. For sec-
ond gauge (non-primary), only product level measure-
ment can be enabled for scan and gauge commands
are not supported.
This setting enables (or) disables servo wire correction.
This is applicable only for Servo gauge. When enabled,
product level is corrected for the temperature effects on
the Servo wire.
Note:
- Servo wire correction is supported by 954 Servo
gauge, if enabled in gauge do not enable this correction
in CIU.
Thermal expansion coefficient of the servo wire. Unit of
measure is 10E-5/C (or) 10E-5/F.
Note:
Thermal expansion coefficient values in ppm (10E-6/C
(or) 10E-6/F) needs to be converted to 10E-5/C (or)
10E-5/F. For example, the value of 16 10E-6/C (ppm)
needs to be converted to 1.6 and then set in Service
tool.
3 - 66