Honeywell CIU 888 Configuration Manual page 98

Part No.: 4417584_Rev12
Getting Started
Properties
Water dip enabled
Water dip offset
Minimum water level
Water address
Water TOI
Water TOR
Water in foreground scan
* Refer to TABLE 3-1 for additional information.
8. Click the Temperature tab, the Properties detail appears.
You can view or edit these properties:
Properties
Temperature enabled
Element type
Lowest element
Position
Temperature address
Temperature TOI
Temperature TOR
Temperature in fore-
ground scan
Temperature profile scan
enable
Configuration Manual
CIU 888
Description
Check to enable water level scan from servo gauge.
Enter water level offset.
Enter minimum water level. This value is used when
no water level is found.
Enter water level transmission address.
Select B, C, E, or M*.
Select M, J, B, L or ZLQ
Check to enable the option.
Description
Check to enable product temperature scan.
Select No element available, MRT, MRT with bottom
spot, MRT with bottom and top spot, One spot
element, Two spot element or MTT.
Enter lowest temperature element position.
Enter product temperature transmission address.
Select: B, C, E, or M*.
Select: C or ZAG*.
Check to enable the option.
This parameter enables / disables the temperature pro-
files data collection from a BPM gauge by CIU.
When this option is selected, CIU collects temperature
profiles data from the BPM gauge that is configured for
product temperature.
Note: CIU would collect the temperature profile data
from the gauge from which product temperature is
scanned.
3 - 68