Network And Dialup Connections - Honeywell Thor VM2 User Manual

Network and Dialup Connections

Start > Settings > Control Panel > Network and Dialup Connections
Set Thor VM2 network driver properties and network access properties. Select a con-
nection to use, or create a new connection.
Create a New Connection
1. On the mobile device, select Start > Settings > Control Panel > Network and Dialup
2. Assuming the connection you want does not exist, double-tap Make New
3. Give the new connection an appropriate name (My Connection @ 9600, etc.). Tap the
4. From the popup menu, choose the port you want to connect to. Only the available
5. Tap the Configure... button.
6. Under the Port Settings tab, choose the appropriate baud rate. Data bits, parity, and
7. Under the Call Options tab, be sure to turn off Wait for dial tone, since a direct
8. TCP/IP Settings should not need to change from defaults. Tap the Finish button to
9. Close the Remote Networking window.
10. To activate the new connection select Start > Settings > Control Panel > PC
11. Select the new connection. Tap OK twice.
12. Close the Control Panel window.
13. Connect the desktop PC to the mobile device with the appropriate cable.
14. Click the desktop Connect icon to test the new connection.
222
Connections. A window is displayed showing the existing connections.
Connection.
Direct Connection radio button. Tap the Next button.
ports are shown.
stop bits remain at 8, none, and 1, respectively.
connection will not have a dial tone. Set the timeout parameter (default is 5
seconds). Tap OK.
create the new connection.
Connection and tap the Change Connection... button.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide