Install Sd Card; Equipment Required; Installation Procedure - Honeywell Thor VM2 User Manual

Install SD Card

An SD card slot is provided for storage expansion.

Equipment Required

The following equipment is user-supplied:
•
•
•

Installation Procedure

1. For convenience, the Thor VM2
2. If the Thor VM2 remains in the
3. Place the Thor VM2 in Suspend by
4. Place the Thor VM2 face down on a
5. Using a #2 Phillips bit loosen the
6. Locate the SD card installation slot.
7. Slide the SD card into the slot. The label side (front) of the SD card
8. Reattach the access panel, torquing the screws to 4-5 inch pounds.
9. If removed, reinstall the Thor VM2 in the dock.
10. Resume the Thor VM2 from suspend.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Torquing tool capable of measuring inch pounds
SD card - The following commercially available SD cards are recommended:
• ATP 2GB Industrial Grade SDHC card - AF2GSDI-5ADXX
• ATP 4GB Industrial Grade SDHC card - AF4GSDI-5ACXX
• SanDisk® 2GB SDHC card - SDSDB-2048
• SanDisk® 4GB SDHC card - SDSDB-004G
#2 Phillips screwdriver bit
can be removed from the dock,
though it is not necessary.
dock, disconnect the power cable
from the dock.
pressing the Power button.
stable surface.
M3 screws and then remove the
tethered access panel with the SIM
label. This panel is on the left hand side when the Thor VM2 is face down with the
top away from the user.
faces toward the back of the Thor VM2.
127