Honeywell Thor VM2 User Manual page 194

Next, create a Bluetooth address bar code label for the Thor VM2.
The format for the bar code label is as follows:
•
•
Create and print the label.
Scan the Thor VM2 Bluetooth address bar code label with the Bluetooth bar code
reader.
The devices are paired. The Bluetooth bar code reader responds with a series of beeps
and LED flashes.
Note: After scanning the Thor VM2 Bluetooth label, if there is no beep and no LED flash from the
Bluetooth bar code reader, the devices are currently paired.
See
Bluetooth Beep and LED Indications
Beep Type from Bluetooth Device
Acknowledge label
Label rejected
Transmission error
Link successful
Link unsuccessful
LED on Bluetooth Device
Yellow LED blinks at 2 Hz
Off
Yellow LED blinks at 50 Hz
Yellow LED blinks at the same rate as the paging beep (1
Hz)
182
Bar code type must be Code 128.
FNC3 character followed by string Uppercase L, lowercase n, lowercase k, uppercase
B and then the Bluetooth address (12 hex digits, no colons). For example,
LnkB0400fd002031.
Bluetooth Beep and LED
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Indications.
Behavior
1 beep
2 beeps at low frequency
Beep will sound high-low-high-low
Beep will sound low-medium-high
Beep will sound high-low-high-low
Behavior
Linking in progress
Disconnected or unlinked
Bluetooth transmission in progress
Paging