Rebooting The Thor Vm2 - Honeywell Thor VM2 User Manual

Press the power button to turn the Thor VM2 on. When the Windows desktop is dis-
played or an application begins, the power up sequence is complete.
After initial power on, the Thor VM2 can be configured to automatically power on. See
Power Controls

Rebooting the Thor VM2

If a USB drive, such as a thumb drive is attached to the Thor VM2, the device
attempts to boot from the USB drive:
•
•
Warmboot
A warmboot reboots the Thor VM2 without erasing any registry data. Configuration set-
tings and data in RAM are preserved during a warmboot. Network sessions are lost and
any data in running applications that has not been previously saved may be lost. CAB
files already installed remain installed.
There are several warmboot methods available:
•
•
•
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
for more information.
If the USB drive contains a bootable sector, the Thor VM2 boots from the
USB drive.
If the USB drive does not contain a bootable sector, the Thor VM2 does
not boot. Remove the USB drive and boot the Thor VM2 again.
Using the Registry, select Start > Settings > Control Panel > Registry and tap the
Warmboot button. The Thor VM2 immediately warmboots.
Using the Start menu, select Start > Run and type WARMBOOT in the text box. Press
Enter. The Thor VM2 immediately warmboots. The WARMBOOT text command is not
case-sensitive.
Use the P1 + P5 + Orange key press sequence to reboot the Thor VM2. The keys must
be pressed in sequence; they do not need to be held down simultaneously.
21