Honeywell Thor VM2 User Manual page 252

Thor VM2 is On and Vehicle Ignition is Switched to Off
Conditions
The Thor VM2 is On and vehicle ignition changes from On to Off.
Result
The Thor VM2 follows the Ignition Control/Ignition Off power scheme with timers reset
at the time Ignition switched to Inactive. UPS charging is disabled.
An example of this case would be a Thor VM2 that is running on UPS and is then
mounted on a dock that has truck power and the ignition switch is already Off.
Auto-On Mode
In Auto-On mode, the Thor VM2 is turned On by the presence of external power with no
user interaction required. Ignition input is ignored when Auto-On Mode is enabled.
Note: When the UPS battery has been depleted or disconnected (the Thor VM2 is first powered
out of the box, the front panel has been replaced, etc.) power the Thor VM2 manually by
pressing the power button. After the initial power up, the Thor VM2 powers on
automatically when power is attached and Auto-On mode is selected.
Thor VM2 is Off
Conditions
The Thor VM2 is Off and gets external power, such as
•
•
•
Result
The Thor VM2 boots. Once booted the Thor VM2 follows the Auto-On power scheme
with timers reset after the boot completes.
Thor VM2 is On
Conditions
The Thor VM2 is On and gets external power, such as
•
•
•
Result
The Thor VM2 continues to run and follows the Auto-On power scheme with timers
reset at the time power was connected.
240
Thor VM2 is installed on a powered dock with the dock power switch On
Thor VM2 is already mounted to a dock and external power is applied to the dock
Thor VM2 is already mounted to a dock and the dock power switch is turned On
Thor VM2 is installed on a powered dock with the dock power switch On
Thor VM2 is already mounted to a dock and external power is applied to the dock
Thor VM2 is already mounted to a dock and the dock power switch is turned On
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide