Chapter 7 - Enabler Installation And Configuration; Introduction; Installation; Installing The Enabler On Mobile Devices - Honeywell Thor VM2 User Manual

CHAPTER
7
ENABLER INSTALLATION AND
CONFIGURATION

Introduction

This section discusses Honeywell supported features with Wavelink Avalanche Mobile
Device Servers. This section is split into three basic areas:
•

Installation

• User Interface
• Enabler Configuration
Installation
To use the Wavelink Avalanche MC System, the following items are required:
• A desktop or laptop PC on which to install the Avalanche MC Console.
• A desktop or laptop PC on which to install the Avalanche Mobile Device Server (this
can be the same PC where the Avalanche MC Console is installed).
• Wavelink Avalanche MC Console 4.2 or later.
• A Wavelink Device License for each client device.
To use Avalanche Remote Control, the follow additional items are required:
• Wavelink Remote Control plug-in, 2.0 or later
• A Wavelink Remote Control License for each client device

Installing the Enabler on Mobile Devices

Supported devices have the Avalanche Enabler installation files loaded, but not
installed, on the mobile device when it is shipped. The installation files are located in
the \System folder on Windows devices.
Note: If the user is NOT using Wavelink Avalanche to manage their mobile device(s), the Enabler
should not be installed on the mobile device(s). Doing so results in unnecessary delays
when booting the device.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide 277