Honeywell Thor VM2 User Manual page 102

•
•
14. While observing the
ATTENTION: For uninterrupted power, electrical supply connections should not be
made at any point after the ignition switch of the vehicle.
15. Use proper electrical and mechanical fastening means for terminating the cable.
16. Provide mechanical support for the cable by securing it to the vehicle structure at
17. Connect the watertight connector end of the power cable to the Thor VM2 dock
18. Secure the power cable to the Thor VM2 using the
19.
20. If using the
21. Press the
22. Press the
Once installation is complete, remember to start the Thor VM2 and select the desired
Power Configuration Mode to enable Auto-On or Manual Control of the Thor VM2 boot
up process.
See the
Note: Ignition control is not available for trucks over 60VDC.
90
Vi - is connected to battery negative.
N
GND is connected to the vehicle chassis ground, which can also be battery negative.
possible to the actual battery terminals of the vehicle. When available, always
connect to unswitched terminals in the vehicle fuse panel, after providing proper
fusing.
Properly sized "crimp" type electrical terminals are an accepted method of
termination. Select electrical connectors sized for use with 18AWG (1mm
conductors.
approximately one foot intervals, taking care not to over tighten and pinch
conductors or penetrate the outer cable jacket.
power connector by aligning the connector pins to the power connector; push down
on the watertight connector and twist it to fasten securely. Flip the power switch on
the back of the dock to On.
Place Thor VM2 in the Dock
Screen Blanking
Power Switch
Power Button
Power Configuration Mode
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Fuse Requirements connect the power cable as close as
feature, install the screen blanking box or switch.
on the back of the Thor VM2 dock.
on the front of the Thor VM2 to turn on the Thor VM2.
control panel.
Strain Relief Cable Clamps.
2
)