Bluetooth - Honeywell Thor VM2 User Manual

Bluetooth

Start > Settings > Control Panel > Bluetooth
Discover and manage pairing with nearby Bluetooth devices.
To use the Honeywell/Intermec SR61 Bluetooth scanner with the Thor VM2:
•
•
1. Make sure the scanner is on and within range of the Thor VM2.
2. Tap the Discover button on the
3. From the list of discovered devices, tap the SR61 scanner and select Pair
Factory Default Settings
Settings
Turn Off Bluetooth
Computer is connectable
Computer is discoverable
Prompt if devices request to pair
Continuous search
Filtered Mode
Printer Port on COM 7:
Logging
Computer Friendly Name
Reconnect
Report lost connection
Report when reconnected
Report failure to reconnect
Clear Pairing Table on boot
Auto Reconnect on Boot
Auto Reconnect
Bluetooth taskbar Icon state and Bluetooth device Icon states change as Bluetooth
devices are discovered, paired, connected and disconnected. There may be audible or
visual signals as paired devices re-connect with the Thor VM2.
•
•
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
The EZPair software must be version 2ab or greater. See the Bluetooth
About control panel for the version installed. Contact
Assistance for software upgrade information.
The EZPair bar code on the Thor VM2 cannot be used to connect the
SR61 scanner. Follow this procedure:
as a Scanner.
The default Bluetooth setting is On.
The Thor VM2 cannot be discovered by other Bluetooth devices when the Computer
is discoverable option is disabled (unchecked) on the Settings panel.
Bluetooth Devices
Enabled
Enabled
Disabled
Enabled
Disabled
Enabled
Disabled (unchecked) by default in both Filtered and Non Filtered
Modes. The option is dimmed in Non Filtered Mode.
Disabled
System Device Name
Enabled
Disabled
Enabled
Disabled
Enabled
Enabled
Technical
tab.
171