Initial Setup For Thor Vm2; Hardware Setup; Software - Honeywell Thor VM2 User Manual

Initial Setup for Thor VM2

This page lists a quick outline of the steps you might take when setting up a new Thor
VM2. More instruction for each step is listed later in this guide.
Contact

Hardware Setup

1.
2.
3. Secure the optional external keyboard to either an integrated or remote mounting
4.
5.
6. Secure all cables in
7. Press the
8. Press the
Note: After the initial power on, the Thor VM2 can be configured to automatically power on,
either when power is attached or the vehicle ignition is turned on.
9. Perform touch screen Calibration.

Software

Languages and Fonts
The Thor VM2 may be shipped with an English only operating system (OS). Contact
Technical Assistance
OS Upgrade
on the Software tab of the
First Boot
When a new Thor VM2 starts up a EULA (End User License Agreement) may be dis-
played on the touch screen. It remains on the screen until the Accept or Decline button
is tapped with a stylus.
Tap the Accept button to accept the EULA terms and the Thor VM2 continues the
startup process. The EULA is not presented to the user again.
Tap the Decline button to decline the EULA and the Thor VM2 reboots. It will continue
to reboot until the Accept button is tapped with the stylus.
Note: The EULA will be presented after any operating system upgrade or re-installation,
including language-specific operating systems.
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
Technical Assistance
Install RAM Mount or
Place Thor VM2 in the
bracket.
Connect Cables for any peripherals.
Connect Power.
Strain Relief Cable
Power Switch
Power Button
for the availability of OS files for other languages. See
for OS update installation information. The language installed is identified
if you need additional help.
Install U Bracket Mount
Dock.
Clamps.
on the dock to the on position.
on the Thor VM2.
About control panel.
to the vehicle.
Thor VM2
7