Honeywell Thor VM2 User Manual page 201
Vehicle-mounted computer with microsoft windows embedded ce 6.0
Hide thumbs
Also See for Thor VM2:
- User manual (366 pages) ,
- Reference manual (196 pages) ,
- Quick start manual (12 pages)
Table of Contents
Advertisement
This panel does not configure the connected device. Please refer to the documentation
for the external connected or wireless device for information on configuring the device.
Note: COM default values are restored after a cold boot or operating system upgrade. COM1
supports 5V switchable power on Pin 9 for tethered scanners.
Power on Pin 9
To configure the COM port to supply power to an external scanner tethered to the COM1
port, check the checkbox for Power on Pin 9 (+5V). The default is On (enabled).
Wireless external scanners use their own power source.
COM2
Start > Settings > Control Panel > Data Collection > COM2 tab
This panel sets communication parameters for any device connected to the external
port.
Adjust the settings and click the OK button to save the changes. Any changes take
effect immediately.
This panel does not configure the connected device. Please refer to the documentation
for the external connected or wireless device for information on configuring the device.
Note: COM default values are restored after a cold boot or operating system upgrade. COM2
supports 5V switchable power on Pin 9 for tethered scanners.
Power on Pin 9
To configure the COM port to supply power to an external scanner tethered to the COM2
port, check the checkbox for Power on Pin 9 (+5V). The default is On (enabled).
Wireless external scanners use their own power source.
Data Options
Start > Settings > Control Panel >Data Collection > Data Options tab
Thor VM2 with with Microsoft Windows Embedded CE 6.0 User Guide
189
Advertisement
Table of Contents
