Table of Contents
Advertisement
By default, ActiveSync does not automatically synchronize all types of information. Use ActiveSync Options to specify the
types of information you want to synchronize. The synchronization process makes the data (in the information types you
select) identical on both your desktop computer and your device.
When installation of ActiveSync is complete on your desktop computer, the ActiveSync Setup Wizard begins and starts the
following processes:
connect your device to your desktop computer,
l
set up a partnership so you can synchronize information between your device and your desktop computer, and
l
customize your synchronization settings.
l
Because ActiveSync is already installed on your device, your first synchronization process begins automatically when you
finish setting up your desktop computer in the ActiveSync wizard. For more information about using ActiveSync on your
desktop computer, open ActiveSync, then open ActiveSync Help.
Initial Setup
The initial setup of ActiveSync must be made via a USB or serial connection. When there is a Connect icon on the desktop,
this section can be bypassed.
Partnerships can only be created using direct serial or a
After the partnerships are established, ActiveSync communication can be initiated using:
USB
l
Serial
l
Wireless
l
Connect via USB
The default connection type is USB Client
To change the connection type or to verify it is set to USB, select
Start > Settings > Control Panel > PC Connection
Tap the Change button. From the popup list, choose
USB Client
This will set up the mobile device to use the USB port. Tap OK and ensure the check box for "Allow connection with desktop
computer when device is attached" is checked.
Tap OK to return to the Control Panel. If desired, any control panel windows may be closed.
IMPORTANT – DO NOT PUT THE MOBILE DEVICE INTO SUSPEND WHILE CONNECTED VIA USB. The device will be
unable to connect to the host PC when it resumes operation.
Connect the correct cable to the PC (the host) and the mobile device (the client) as detailed below. USB will start automatically
when the USB cable is connected, not requiring you to select "Connect" from the start menu.
Cable for USB ActiveSync Connection:
MX3069CABLE- USB-Client cable, VX3Plus USB Client port to PC/Laptop USB port.
D9 connector connects to port marked USB-C on the VX3Plus endcap. If there is no port on the endcap, USB cannot be
l
used for ActiveSync.
The USB type A connector connects to a standard USB port on a PC or laptop.
l
USB
cable connection.
3-21
Advertisement
Table of Contents
